Furuno DRS4DL Install Manual page 10

1. INSTALLATION
• The cable must be fixed so no tension is applied to the connectors. To prevent
tension, create a loop in the cable close to the sensor and tie the loop with cable
ties, as in the figure below.
• Wrap the junction of the connectors with self-vulcanizing tape for waterproofing.
• Fasten the cable to the mast, etc. at the neck of each connector with a cable tie.
6. Connect the power/LAN cable to the power source and display unit.
Installation with the radome mount
The optional radome mount lets you fasten the radar sensor to a mast on a sailboat.
Name, Type: Radome Mount, OP03-209
Code No.: 001-078-350
Mounting plate
Support plate (1)
Support plate (2)
Bracket (1)
Bracket (2)
Fixing plate
Hex bolt w/washer
Hex bolt w/washer
How to assemble the bracket
1. Fasten the fixing plates to brackets (1) and (2) with four M8 20 hex bolts.
2. Fit brackets (1) and (2) loosely with support plates (1) and (2) using four M4 12
hex bolts, so that the gap between the brackets can be adjusted.
3. Place the mounting plate on the bracket and fix it loosely with four M8 20 hex
bolts.
Connect cables
Wrap junction with self-vulcanizing tape
Name
03-018-9001-0
03-018-9005-0
03-018-9006-0
03-028-9101-1
03-028-9101-2
03-028-9103-1
M8 20 SUS304
M4 12 SUS304
Loop cable and tie loop with cable ties.
The minimum bend diameter is 80 mm.
Type
100-206-740-10
100-206-780-10
100-206-790-10
100-206-811-10
100-206-812-10
100-206-831-10
000-162-955-10
000-162-956-10
5
Code No. Qty
1
1
1
1
1
2
8
4