Aztec EDGEWINDER Owner's Manual page 28

Tampering and Altering
Tampering with or altering the emission control system may increase emissions beyond the legal
limit. Among those acts that constitute tampering are:
•
Removal or alteration of any part of the intake, fuel, or exhaust systems.
•
Altering or defeating the governor linkage or speed-adjusting mechanism to cause the engine
to operate outside its design parameters.
Problems That May Affect Emissions
If you are aware of any of the following symptoms, have your engine inspected and repaired by an
authorized servicing dealer:
•
Hard starting or stalling after starting.
•
Rough idle.
•
Misfiring or backfiring under load.
•
Afterburning (backfiring).
•
Black exhaust smoke or high fuel consumption.
Maintenance
Follow the MAINTENANCE SCHEDULE on pg 23. Remember that this schedule is based on the
assumption that your machine will be used for its designed purpose. Sustained high-load or high-
temperature operation, or use in unusually wet or dusty conditions, will require more frequent
service.
Specifications
ITEM
Spark plug gap
Idle speed
Valve clearance (cold)
Other specifications
Quick Reference Information
Engine Oil
Spark Plug
Maintenance
05-2017
SPECIFICATION
0.70-0.80 mm
(0.028-0.031 in)
1,400 +/- 150 rpm
IN: 0.15 +/- 0.02 mm
EX: 0.20 +/- 0.02 mm
No other adjustments needed.
SAE 10W-30, API SF or SL, for general use.
Refer to pg 17
BPR5ES (NGK)
Before each use:
•
•
First 20 hours:
•
Subsequent:
Refer to the MAINTENANCE SCHEDULE on
pg 22-23.
EDGEWINDER OWNER'S MANUAL PAGE 28
MAINTENANCE
Refer to pg 21
See your authorized HONDA
dealer
See your authorized HONDA
dealer
Check engine oil level. Refer to pg 17
Check air filter. Refer to pg 20
Change engine oil. Refer to pg 18