Transporting The Edgewinder; Edgewinder Clean-Up; Edgewinder Belt & Brush Maintenance - Aztec EDGEWINDER Owner's Manual

TRANSPORTING THE EDGEWINDER

To transport the Edgewinder, first review the SAFETY INFORMATION on pg 3-8.
The machine must be on a level surface, with the engine switch in the OFF position, and the propane
tank valve in the CLOSED position. If the engine has been running, allow to cool at least 15 minutes
before loading the engine-powered equipment onto a transport vehicle. A hot engine and exhaust
system can burn you.
Remove the propane tank from the machine, or disconnect the connection and securely fasten tank
to machine. Pull the Edgewinder in reverse or push forward by raising brush off floor.
EDGEWINDER CLEAN UP
First, refer to the SAFETY INFORMATION on pgs 3-8. Once the job is complete for the day/night,
clean up is required. The manufacturer's and engine warranty will be voided if the equipment is not
properly maintained. Clean the entire machine after each use:
A. Turn the propane tank valve clockwise to CLOSED position and turn the engine key to OFF
position.
B. Review the SAFETY INFORMATION on pg 3-8.
C. Review the TRANSPORTING THE EDGEWINDER above, to properly tilt the machine on
the right side, from operator's position.
D. Check the machine for possible loose nuts and bolts; tighten and secure as needed.
E. Rinse the underside of the machine with water after use.
Brush should be replaced when bristle length reached ½".
F.
EDGEWINDER BELT & BRUSH MAINTENANCE
Brush Replacement:
1.) First, refer to the SAFETY INFORMATION on pgs 3-8.
2.) Access underside as directed.
3.) Remove 4 nuts with a 9/16" wrench or socket.
4.) Remove and replace brush.
5.) Replace washers and nuts.
Belt Replacement:
1.) Remove brush as directed above.
2.) Remove belt from the idler pulley and engine sheave.
3.) Pull belt out from driveshaft area.
4.) Reverse this procedure for belt replacement.
05-2017
EDGEWINDER OWNER'S MANUAL PAGE 14