Oil Filter Change - Aztec EDGEWINDER Owner's Manual

OIL FILTER CHANGE (IF EQUIPPED)
Change the oil filter every 100 hours of operation.
1.) Drain engine oil into a suitable container.
2.) Rotate the oil filter (A) counterclockwise to remove it.
3.) Coat a film of clean engine oil on seal of new filter.
4.) Install new filter rotating it clockwise until seal contacts mounting surface (B). Then rotate
filter 3/4 turn more by hand.
5.) Supply engine oil as specified.
6.) Run the engine for about 3 minutes, stop engine, and check oil leakage around the filter.
7.) Add oil to compensate for oil level drop due to oil filter capacity (See OIL LEVEL CHECK on
pg 17).
05-2017
Before removing the oil filter, place a suitable pan under filter connection.
EDGEWINDER OWNER'S MANUAL PAGE 19