Getting Started - Edgewinder - Aztec EDGEWINDER Owner's Manual

depending on the equipment on which the engine is used. Refer to the equipment specifications.
lower than 1800 RPM, the clutch will disengage; brushes/pads will stop.
exists, contact an authorized service center.
functions include the following: hours, service alert and tachometer; see ENGINE MAINTENANCE
METER instructions on pg 22.

GETTING STARTED - EDGEWINDER

1.) Once all of the BEFORE OPERATION CHECKLIST on pgs 9-10 is completed, open the
LPG tank valve (counter clockwise).
2.) Adjust the machine handle to comfortable position using pin provided to secure in place.
3.) Set the throttle control switch to the SLOW position.
4.) Turn key to START position until engine starts. Starter should not be engaged for more than
10 seconds at a time. If hard starting is a problem, carefully review BEFORE OPERATION
CHECKLIST on pg 9-10. As soon as engine starts, immediately move throttle cable to
SLOW/idle position or into desired engine speed. The clutch will disengage when throttle is
moved to the SLOW position.
5.) Engage the brush by moving the cable switch past ¼ throttle (1900 RPM). Brush should be
replaced when bristle length wears down to ½".
6.) Operate engine throttle at ½ speed for stripping and scrubbing.
05-2017
Engine speed not to exceed 3400 RPM. High and low idle speeds may vary
This machine is not suitable for picking up hazardous dust.
Do not use this machine on surfaces with a gradient exceeding 2%.
This machine is supplied with a centrifugal clutch. When the engine RPM is
All machines are equipped with tamper proof fuel systems. If a fuel problem
All machines are equipped with a multi-function maintenance meter. The
EDGEWINDER OWNER'S MANUAL PAGE 13