GE Multilin 3 Series Manual page 32

CONVERTING A SAVED MIF II OR MIV II SETPOINT FILE
Notehe one that is added in
26
If the MIF II or MIV II setpoint file cannot be converted due to an incompatible 350
order code, the following message is shown.
3. Select the Firmware Version, and Order Code options for the new setpoint file.
4. For future reference, enter some useful information in the Description box to facilitate
the identification of the device and the purpose of the file.
5. To select a file name and path for the new file, click the button beside the File Name
box.
6. Select the file name and path to store the file, or select any displayed file name to
replace an existing file. All 3 Series setpoint files should have the extension '.sr3' (for
example, '350 1.sr3').
File names for setting files cannot have a decimal point other than the one that is added in
front of sr3.
7. Click the box beside Initialize Settings from MIF II or MIV II Settings File.
8. To select an existing MIIF II or MIV II file, click the button beside the Initialize Settings
from MIF II/MIV II Settings File box and navigate to the file.
9. Click OK to complete the process. Once this step is completed, the new file, with a
complete path, is added to the 3 Series software environment. In addition a
Conversion Report is generated, as described in the following section.
For more information on the EnerVista 3 Series Setup software, refer to the 350 Feeder
Protection System Instruction Manual at
CHAPTER 2: CONVERTING SETTINGS FILES
http://www.gegridsolutions.com
3 SERIES RETROFIT – INSTRUCTION MANUAL