HP E1563A User Manual page 59

:MEMory:SIZE?
:PEEK?
Parameters
Comments
4M, 8M, 16M, etc. (e.g., 4E6, 8E6, 16E6, etc.) up to the actual size as noted in the
following DIAGnostic:MEMory:SIZE? command.
DIAGnostic:MEMory:SIZE? queries the RAM size value in calibration memory.
The value returned is the actual amount of memory, not the abbreviated industry
notation for memory size. The value returned for each size is shown below:
RAM industry notation
DIAGnostic:PEEK? <reg_number> queries the specified register and returns the
contents of the register.
Parameter
Name
reg_number
•
See Appendix B for register bit definitions.
•
You can read the following digitizer registers using the register number:
reg_number Register Description (base + register offset)
0 Manufacturer ID Register (base + 00
1 Device Type Register (base + 02
2 Status/Control Register (base + 04
3 Offset Register (base + 06
4** FIFO High Word Register (base + 08
5** FIFO Low Word Register (base + 0A
6 Interrupt Control Register (base + 0C
7 Interrupt Sources Register (base + 0E
8 CVTable Channel 1 Register (base + 10
9 CVTable Channel 2 Register (base + 12
10 CVTable Channel 3 Register (base + 14
11 CVTable Channel 4 Register (base + 16
actual size value
4M
8M
16M
32M
64M
128M
Parameter Range of
Type
numeric
)
16
Digitizer Command Reference
4,194,304
8,388,608
16,777,216
33,554,432
67,108,864
134,217,728
Default
Values Units
0 to 31 none
)
16
)
16
)
16
)
16
)
16
)
16
)
16
)
16
)
16
)
16
)
16
59