HP E1563A User Manual page 137

TRIG:MODE SLAVe0 pairs TTLT0 (sample) with TTLT1 (trigger)
A SLAVe0 module will function with other SLAVe0 modules and
the MASTer0 module.
1) The trigger source from the slave can be set
with the Trigger Source/Control Register bits
0,1,2,3,4,7,8,9,12,13,14, and 15. .
MODE
SLAVe0
SLAVe2
SLAVe4
SLAVe6
Appendix B
Figure B-2. Slave Module Configuration.
Sample Trigger
signal signal
TTLT0 TTLT1
TTLT2 TTLT3
TTLT4 TTLT5
TTLT6 TTLT7
HP E1563A and E1564A Register-Based Programming 137
2) SLAVe0 sets the TTLT0 line as if
and sets the TTLT1 line as if the
source is TTLT0
trigger source is
TTLT1
dedicated for synchronization between the
modules in the master-slave mode. You should
not use these lines for any other purpose.
the sample
. These lines are simply