Advertisement
1. Outline
The M30102T-PTC is a converter board for M30102 Group
for connecting the pod probe M30100T-PRB to the foot
pattern for 48-pin 0.5-mm-pitch QFP (48P6Q-A).
2. Package Components
(1) M30102T-PTC converter board
(2) YQPACK048SD (made by Tokyo Eletech Corporation)
(3) NQPACK048SD (made by Tokyo Eletech Corporation)
(4) YQ-GUIDE (4 pieces)
(made by Tokyo Eletech Corporation)
(5) Screwdriver
(6) M30102T-PTC User's Manual (This manual)
3. Specifications
Table 1 Specifications
Applicable package
Insertion/removal
iterations of
connector
4. Usage
(see Figure 2)
The M30102T-PTC can be used for debugging and board
mounted evaluation in common by mounting the
NQPACK048SD on the target board.
a. For debugging
Mount the NQPACK048SD and the YQPACK048SD in
that order on the foot pattern of the target board. Then
attach the YQ-GUIDE's to the YQPACK048SD to connect
the M30102T-PTC. (Do not use the four screws included
in the YQPACK048SD package.) Finally, connect the
pod probe M30100T-PRB to the M30102T-PTC.
b. For board-mounted evaluation
Mount the M30102 MCU and the HQPACK048SD (sepa-
rately available) in that order on the NQPACK048SD on
the target system. Then secure the screws.
Before using the M30102T-PTC, be sure to read "7. Precau-
tions" (page 4).
(see Figure 1)
48P6Q-A
(48-pin 0.5-mm-pitch QFP)
20 times guaranteed
(2) YQPACK048SD
(4) YQ-GUIDE (x4)
Figure 1 Package components of the M30102T-PTC
Figure 2 Usage of the M30102T-PTC
( 2 / 4 )
(1) M30102T-PTC
(3) NQPACK048SD
(5) Screwdriver
Advertisement
