Configuring Thec; Determine And Configure The Ip Address; Ettings - Raco Catalyst Owner's Manual

2. Catalyst Configuration
This section will cover setting up the Catalyst Ethernet Module for your network and
assigning alarm channels to the desired SNAs (System Net Addresses).
A. Configuring the Catalyst Ethernet Module IP Settings
The Catalyst's Ethernet Module's IP settings must be configured in order to connect to
the network. The current Ethernet Module's IP address must initially be determined
and then configured to correctly match your network setup.

Determine and configure the IP Address

Connect a standard RJ-45 Ethernet cable to the Ethernet Module. This should
1.
be on a network that is accessible to the PC and the PLC to be monitored.
Saved: 2015-08-03
Filename:
Catalyst EtherNet Option Setup R5 V01.docx
RACO Manufacturing and Engineering
Copyright © 1998-2015 RACO. All rights reserved.
Page 6 (37)