B. Preparing the Catalyst for Testing
This procedure sets up the Catalyst to give an alarm when it receives the correct data
from ComTest Pro.
Verify the Catalyst's Ethernet Connectivity
This section is a brief recap of the Catalyst setup in Section 2. If you have just
completed that section, you may skip these steps.
1. Connect the Catalyst to the same Ethernet subnet as the PC that ComTest Pro
is running on.
2. Check that the IP setting of the Catalyst using the RACO IP Config tool.
3. Enter the IP address of the Catalyst into a web browser on the PC and verify
that the Catalyst status screen is displayed similar to this:
Saved: 2015-08-03
Filename:
Catalyst EtherNet Option Setup R5 V01.docx
RACO Manufacturing and Engineering
Copyright © 1998-2015 RACO. All rights reserved.
Page 30 (37)