Remote Start Abort Message; To Enter Remote Start Mode; To Exit Remote Start Mode Without Driving The Vehicle - Jeep GRAND CHEROKEE 2017 User Manual

• Vehicle alarm system indicator flashing
• Ignition in STOP/OFF position
• Fuel level meets minimum requirement
WARNING!
• Do not start or run an engine in a closed
garage or confined area. Exhaust gas
contains Carbon Monoxide (CO) which
is odorless and colorless. Carbon Mon-
oxide is poisonous and can cause seri-
ous injury or death when inhaled.
• Keep key fobs away from children. Op-
eration of the Remote Start System,
windows, door locks or other controls
could cause serious injury or death.

Remote Start Abort Message

The following messages will display in the
instrument cluster display if the vehicle fails
to remote start or exits remote start prema-
turely:
• Remote Start Cancelled — Door Open
• Remote Start Cancelled — Hood Open
• Remote Start Cancelled — Fuel Low
• Remote Start Aborted Timer Expired
• Remote Start Aborted Liftgate Open
• Remote Start Disabled — Start Vehicle To
Reset
The instrument cluster display message stays
active until the ignition is turned to the ON/
RUN position.

To Enter Remote Start Mode

Push and release the Remote Start button on
the key fob twice within five seconds. The
vehicle doors will lock, the turn signals will
flash twice, and the horn will chirp twice.
Then the engine will start, and the vehicle
will remain in the Remote Start mode for a
15-minute cycle.
NOTE:
• If an engine fault is present or fuel level is
low, the vehicle will start and then shut
down in 10 seconds.
• The park lamps will turn on and remain on
during Remote Start mode.
• For security, power window operation is
disabled when the vehicle is in the Remote
Start mode.
• The engine can be started two consecutive
times (two 15-minute cycles) with the key
fob. However, the ignition must be placed
in the ON/RUN position before you can
repeat the start sequence for a third cycle.
To Exit Remote Start Mode Without
Driving The Vehicle
Push and release the Remote Start button
one time or allow the remote start cycle to
complete the entire 15-minute cycle.
NOTE:
To avoid unintentional shutdowns, the system
will disable the one time push of the Remote
Start button for two seconds after receiving a
valid Remote Start request.
17