Installing The Controller In A Previously Configured Server - HP P600 User Manual

10 HP Smart Array P600 Controller User Guide
The server is now ready to use. If you want to create additional logical drives
("Configuring an array" on page 19), you may now do so.
Installing the controller in a previously configured
server
1. Back up any data on the system.
2. Update the server firmware ("Updating the firmware" on page 17).
3. If the new controller is to be the boot device, install the device drivers
("Installing device drivers" on page 27). Otherwise, continue with step 4.
4. Install the controller hardware ("Installing the controller hardware" on page
11).
5. Set the controller order.
6. Update the controller firmware ("Updating the firmware" on page 17).
7. If the controller is not going to be the boot device, install the device drivers
("Installing device drivers" on page 27).
8. Update the Management Agents ("Installing Management Agents" on page
27) if new versions are available.
The server is now ready to use. If you want to create additional logical drives,
you may now do so.