Nokia 32 Quick Manual page 2

1.2 Configuring Nokia 32 terminal to analog fax mode
You can configure the Nokia 32 terminal to two different analog fax modes using either Nokia 32
Configurator software or the following command strings given by a DTMF landline telephone connected to
the trunk connector of the Nokia 32 terminal:
**####**1234#12**0# - for analog fax mode
**####**1234#12**2# - for permanent analog fax mode
After the command, key in 555**# to save the new settings and restart the terminal.
1.3 Using Nokia 32 terminal in analog fax mode
The Nokia 32 terminal uses the analog fax mode as a default.
1.3.1 Sending faxes
1. Connect the analog fax machine to the trunk connector of the Nokia 32 terminal.
2. Dial *01* to inform the Nokia 32 terminal about the outgoing fax call.
3. Dial the recipient's number.
Example: *01*1234567
1.3.2 Receiving faxes
Incoming faxes are received the same way as using a fixed line (PSTN).
If the Nokia 32 terminal does not receive information about the incoming call type from the
GSM network, dial *01#* to force the Nokia 32 terminal to receive the next incoming call as a
fax call. When a fax is received, this temporary setting is disabled. You can also disable the
setting by dialling #01#*.
1.3.3 Light indicators
When the Nokia 32 terminal is in analog fax mode, LEDs 2 and 3 are green. During a fax
call, LED 3 blinks green.
1.4 Using Nokia 32 terminal in permanent analog fax mode
You can set the Nokia 32 terminal to permanent analog fax mode. In this mode, all calls are handled as
fax calls.
When the Nokia 32 terminal is in permanent fax mode, the actual GSM voice channel enhancements are
not in use and thus the voice quality may be poor.
1.4.1 Sending faxes
1. Connect the analog fax machine to the trunk connector of the Nokia 32 terminal.
2. Dial the recipient's number.
The prefix *01* is not needed in the permanent analog fax mode.
NOKIA 32 ANALOG FAX
QUICK GUIDE
2 (3)