Adjusting The Winder; Setting The Fill Volume - DURKOPP ADLER 512-211-01 Service Instructions Manual

10 Adjusting the winder

10.1 Setting the fill volume

Correct setting
1. Wind onto an empty bobbin ( Operating manual, Section 4.4).
 Winding stops automatically when the bobbin is filled to approx.
Fig. 25: Setting the winder fill volume
(1) - Adjusting screw
(2) - Clamping screw
Adjusting steps
Rough adjustment
1. Loosen the clamping screw (2).
2. Align the actuating lever (4):
3. Tighten the clamping screw (2).
Fine adjustment
4. Loosen the adjusting screw (1).
34
0.5 mm below the bobbin edge.
NOTICE
Property damage may occou!
When operated without sewing material the sewing feet and bobbin
case in the hook can be damaged.
Enable the winding mode ( Operating manual, Section 5.8
Winding) and remove the bobbin case from the hook to perform a
test winding process.
• Smaller fill quantity: Push towards bobbin.
• Larger fill quantity: Push away from bobbin.
(3) - Thread guide plate
(4) - Actuating lever
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016
Adjusting the winder