Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for CLF Ares
Summary of Contents for CLF Ares
- Page 1 ARES manual WWW.CLF-LIGHTING.COM V1.0 APRIL 2017...
-
Page 2: Table Of Contents
Static Color options Auto Show Master / Slave Personality Fans Led power Dimmer Speed Key-Lock W-DMX Calibration Refresh rate LCD brightness DMX Hold Information Software type Usage time Temperature Factory reset DMX protocols Onboard control menus Blow-out Diagram Specifications WWW.CLF-LIGHTING.COM... -
Page 3: Dimensions
Dimensions All dimensions are in millimeters WWW.CLF-LIGHTING.COM... -
Page 4: Safety Information
Isolate the fixture from power immediately if the power plug or any seal, cover, cable, or other component is damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs have been completed. WWW.CLF-LIGHTING.COM... - Page 5 Do not connect any other type of device to these sockets. Do not stick filters, masks or other materials to any optical component, besides the optional CLF Ares filters. Do not modify the fixture in any way not described in this manual.
-
Page 6: Fixture Overview
Omega bracket with Quicklock # 520114 (chrome) or # 520113 (black) (Optional) Safety cable attachment point G Clamp with Quicklock # 875760 (Optional) AC mains power i nput Display DMX input Antenna Wireless Solutions AC mains power through DMX output WWW.CLF-LIGHTING.COM... -
Page 7: Introduction
Warning! Check that the voltage range specified on the fixtures serial number label matches the local AC mains power voltage before applying power to the fixture. The fixtures accepts AC mains power at 100-240 V nominal, 50/60 Hz. Do not apply AC mains power to the fixture at any other voltage than specified. WWW.CLF-LIGHTING.COM... -
Page 8: Power Cables
1. Connect the DMX data output from the controller to the 3-pin XLR connector of the nearest fixture. 2. Connect the DMX output of the fixture closest to the controller to the DMX input of the next fixture and continue connecting fixtures output to input. WWW.CLF-LIGHTING.COM... -
Page 9: Physical Installation
(see “Fixture overview” on page 4). Do not use any other part of the fixture as a safety cable attachment point. WWW.CLF-LIGHTING.COM... -
Page 10: Setup
“ : OFF ”. Holding the MENU and ENTER button for more than 3 seconds, the wireless board will reset. Do not use Wireless DMX and Wired DMX at the same time because it will give unwanted interference WWW.CLF-LIGHTING.COM... -
Page 11: Control Mode
DMX control mode is selected in the CONTROL MODE menu. The fixture can be controlled with 7 DMX control modes: 11ch 16ch 21ch 27ch 30ch RGBW Strobe Dimmer Function set Macro color LED block ( Dimmer) LED block ( RGBW LED block ( Dimmer speed Effect Dimmer / Auto speed WWW.CLF-LIGHTING.COM... -
Page 12: Static Color Options
15) Auto 15 20) Auto 1-19 cycle Master/Slave You can choose between master or slave functioning. The chosen mode is visible in the homescreen. The fixture will automatically go to slave function when no DMX signal is offered. WWW.CLF-LIGHTING.COM 10.0... -
Page 13: Personality
Here you can set all functions for the fixture. Information Factory REset Resets the fixture to its factory default settings. Please reboot power before reset takes effect. WWW.CLF-LIGHTING.COM 11.0... -
Page 14: Dmx Protocols
4 CH Function Value Setting Remark 0-100% 000 - 255 0-100% Green 000 - 255 Blue 0-100% 000 - 255 White 0-100% 000 - 255 WWW.CLF-LIGHTING.COM 12.0... - Page 15 000 - 004 No Function Macro color 005 - 255 Macro color rotation effect 0 - 100 Green 0 - 100 Blue 0 - 100 White 0 - 100 000 - 009 No function 010 - 255 10000K - 2500K WWW.CLF-LIGHTING.COM 13.0...
- Page 16 No Function Macro color 005 - 255 Macro color rotation effect 0 - 100 000 - 255 Green 0 - 100 000 - 255 000 - 255 Blue 0 - 100 White 0 - 100 000 - 255 WWW.CLF-LIGHTING.COM 14.0...
- Page 17 Auto program 16 170 - 179 Auto program 17 180 - 189 Auto program 18 190 - 199 Auto program 19 200 - 255 Auto program 20(Auto program 1-19 cycle) No function Speed 1-255 AUTO Speed or Dimmer Speed WWW.CLF-LIGHTING.COM 15.0...
- Page 18 Green 0-100% LED block 3 -Blue 3 0-100% LED block 3 -White 3 0-100% LED block 4 -Red 4) 0-100% LED block 4 - Green 0-100% LED block 4 -Blue 4 0-100% LED block 4 -White 4 0-100% WWW.CLF-LIGHTING.COM 16.0...
- Page 19 000 - 255 000 - 255 Blue 1 LED block 1 - Blue 1 (0-100%) White 1 LED block 1 - White 1 (0-100%) 000 - 255 Red 2 LED block 2 - Red 2 (0-100%) 000 - 255 WWW.CLF-LIGHTING.COM 17.0...
- Page 20 Auto program 16 170 - 179 Auto program 17 180 - 189 Auto program 18 190 - 199 Auto program 19 200 - 255 Auto program 20(Auto program 1-19 cycle) No function Speed 1-255 AUTO Speed or Dimmer Speed WWW.CLF-LIGHTING.COM 18.0...
- Page 21 No Function Macro color 005 - 255 Macro color rotation effect Red dimmer (0-100%) 000 - 255 Green Green dimmer (0-100%) 000 - 255 Blue Blue dimmer (0-100%) 000 - 255 White White dimmer (0-100%) 000 - 255 WWW.CLF-LIGHTING.COM 19.0...
- Page 22 Auto program 16 170 - 179 Auto program 17 180 - 189 Auto program 18 190 - 199 Auto program 19 200 - 255 Auto program 20(Auto program 1-19 cycle) No function Speed 1-255 AUTO Speed or Dimmer Speed WWW.CLF-LIGHTING.COM 20.0...
- Page 23 LED block 1 dimmer 000 - 255 Red 1 LED block 1 - Red 1(0-100%) 000 - 255 Green 1 LED block 1 - Green 1 (0-100%) 000 - 255 000 - 255 Blue 1 LED block 1 - Blue 1(0-100%) WWW.CLF-LIGHTING.COM 21.0...
- Page 24 Auto program 16 170 - 179 Auto program 17 180 - 189 Auto program 18 190 - 199 Auto program 19 200 - 255 Auto program 20(Auto program 1-19 cycle) No function Speed 1-255 AUTO Speed or Dimmer Speed WWW.CLF-LIGHTING.COM 22.0...
-
Page 25: Fans
Default : AUTO :1,Speed: 0 Software type V . X XX TOTAL Xxxx hours INFO Usage time Use time reset(password) RESET Temperature XXX℃ FACTORY SET LOAD Default : 255 0-255 Default : 255 MANUAL CALIB Green 0-255 Default : 255 Blue 0-255 WWW.CLF-LIGHTING.COM 23.0... -
Page 26: Blow-Out Diagram
011831 Fan fixed bracket 011549 Power supply 005479 005426 The fan of power supply 005472 DMX output 005428 Bracket 011837 Power output 005471 Arch chassis 011769 Wireless receiving 011829 Knob cover 011752 Side parts 2 011781 Knob 011784 WWW.CLF-LIGHTING.COM 24.0... -
Page 27: Specifications
PowerCON TRUE 1 input socket ® AC power throughput PowerCON TRUE 1 output socket 5 pin locking XLR (3 pin optional with # CLF-13-453 & CLF-13-454) DMX data in/out Electrical AC power 100-240V nominal, 50/60 Hz Maximum total power consumption... - Page 28 ARES CLFLIGHTING WWW.CLF-LIGHTING.COM...
Need help?
Do you have a question about the Ares and is the answer not in the manual?
Questions and answers