Perform Engine Maintenance - Genie Z-45/25 Bi-Energy Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
8 Remove the hydraulic tank from the machine.
Component damage hazard. The
hydraulic tank is plastic and may
become damaged if it is allowed to
fall.
9 Remove the suction strainer from the tank and
clean it using a mild solvent.
10 Rinse out the inside of the tank using a mild
solvent.
11 Install the suction strainer and drain plug using
a thread sealer on the threads.
12 Place the hydraulic tank onto the machine.
13 Install the hydraulic hoses.
14 Install the hydraulic tank mounting fasteners
and torque to specification. Refer to Section 2,
Specifications .
Component damage hazard. The
hydraulic tank may become
damaged if the tank mounting
fasteners are over tightened.
15 Fill the tank with hydraulic oil until the fluid is
within the and
FULL ADD
tank. Do not overfill.
16 Clean up any oil that may have spilled. Properly
discard of oil.
17 Operate all machine functions through a full
cycle and check for leaks.
3 - 38
marks on the hydraulic
Genie Z-45/25 Bi-Energy and Genie Z-45/25J Bi-Energy
E-2

Perform Engine Maintenance

Engine specifications require that
this procedure be performed
every 2000 hours or every two
years, whichever comes first.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life.
Failure to perform the maintenance procedures
can lead to poor engine performance and
component damage.
Required maintenance procedures and additional
engine information are available in the
Kubota Z482-E Operator's Manual
(Kubota part number 16676-89163).
Kubota Z482-E Operator's Manual
Genie part number
To access the engine:
1 Remove the engine pivot plate latch retainer.
2 Open the engine pivot plate latch and swing the
engine out away from the machine.
July 2004
REV A
52958
Part No. 106488