Honeywell T6 Pro Z-Wave Professional Install Manual page 11

System operation setting
Press the Mode button to cycle to the next available
1
System mode.
2 Cycle through the modes until the required System
mode is displayed and leave it to activate.
System modes:
• Heat: Controls the heating system.
• Cool: Controls the cooling system.
• Off: Turns the heating and cooling systems off.
• Auto: When enabled, the thermostat will
automatically use heating or cooling to reach the
desired temperature.
• Em Heat: Controls auxiliary or emergency heat; only
available on systems with a heat pump.
NOTES:
• Em Heat and Auto modes may not appear on the
thermostat screen, depending on your equipment
and how the thermostat was configured.
• Em Heat is only available if the thermostat is
configured to control a heat pump and an auxiliary/
emergency heat stage.
• When Auto mode is enabled and initiated, Auto
Chg. On will appear in the upper-right corner of the
thermostat home screen, and the active mode (Heat
or Cool) will be displayed. Auto mode is disabled by
default. To enable it, see "Installer setup – advanced
menu" on page 14 and 16.
Fan operation setting
Press the Fan button to cycle to the next
1
available Fan mode.
2 Cycle through the modes until the required
Fan mode is displayed and leave it to
activate.
NOTE: Available Fan modes vary with system
settings.
Fan modes:
• On: The fan will run continuously.
• Auto: The fan will run only when the heating
or cooling system is on.
• Circ: The fan will run at random intervals at
least 35% of the time to keep air circulating
throughout your home.
11
AM
Following Schedule
Mode Fan
Heat Auto
Away Home Sleep
Mode Menu Fan
AM
Following Schedule
Mode Fan
Auto
Cool
Away Home Sleep
Mode Menu Fan
AM
Following Schedule Auto Chg. On
Mode Fan
Auto
Wake Away Home Sleep
Mode Menu Fan
AM
Following Schedule
Mode Fan
Heat Auto
Away Home Sleep
Mode Menu Fan