Z-Wave Connection Status - Honeywell T6 Pro Z-Wave Professional Install Manual

Advanced Z-Wave temperature reporting
This thermostat may be configured to report the actual room temperature in
a higher resolution than can be shown on the thermostat display. The default
temperature reporting resolution is 1 °F or 0.5 °C. When configured to ADVANCED,
the temperature reporting resolution will be 0.5 °F or 0.25 °C. To change default
temperature reporting to a higher resolution, go to thermostat MENU/Z-WAVE
SETUP/TEMP REPORT and set to ADVANCED. The temperature is reported by
every displayed value change, and no later than 2 hours from last report.
NOTE: When higher temperature resolution reporting set, you may experience
different resolution of temperature displayed on the thermostat and Z-Wave
controller.

Z-Wave connection status

Wifi is on and
connected
Z-Wave connection status is located in the upper-right corner of the screen.
• Thermostat is included and connected to a Z-Wave network.
or wifi is not setup
Wifi is on and
connected
• Thermostat is excluded from a Z-Wave network.
Wifi is on and
connected
Wifi is off
• Thermostat is either included in a Z-Wave network but the Z-Wave signal
is lost, or is included but AC power is lost (battery used as backup). In this
or wifi is not setup
or wifi is not setup
case, Z-Wave radio is turned off to preserve battery life. AC power must be
restored or you have to change the power mode. It can be done via excluding
Wifi is off
thermostat from Z-wave network and including again in battery power mode
Wifi is off
where batteries are used as main power source. You can check the actual
power mode in the thermostat MENU/DEVICE INFO.
10