Timing Requirement - Philips 160EL1SB/00 Service Manual

3.2.2 Software control functions via OSD /control adjustable functions:
Please refer to following Hudson9 OSD definitions, if any deviation, then refer to PVT Exit sample.
ITEM
1 OSD DEFINITIONS
2 OSD LANGUAGES
3 OSD TREE
4 POWER ON LOGO
3.3

Timing requirement

Factory Preset mode definition:
1. Perfect FOS while presenting those timings.
2. Will specify those timing in User's Manual
Preset mode definition:
1. Need to support those timings.
2. Perfect FOS after auto adjustment.
User mode
1. Can save those timing that not in Preset mode and can be showed (not over scalar or Panel
spec.)
2. It needs to reserve the 10 timings space in memory size.
3.3.1 Mode storing capacity
Factory preset modes
User modes
3.3.2 Factory preset modes (14 modes)
Factory modes and preset modes are defined in the enclosed timing table file
1.0
Rev :
2008/12/31
Date :
ph il ips
: 14
: 23
160E1
Type :
PHILIPS
Brand :
Reset -
No: Exit
Yes: Auto adjustment for
displaying timing mode and
recall factory preset
9 LANGUAGES
Power On Logo: Power On
Show up Philips logo 3
seconds
Change to input signal.
This picture is reference only.
The official drawing will send
out by PM.
15.6" Wide LCD Monitor
8 of 20
Page :