Installing The Transceiver - Kenwood TK-6110 Instruction Manual

■

Installing the Transceiver

FOR PASSENGER SAFETY, INSTALL THE TRANSCEIVER SECURELY, USING THE
SUPPLIED MOUNTING BRACKET, SO THE TRANSCEIVER WILL NOT BREAK LOOSE IN
THE EVENT OF A COLLISION.
1 Mark the position of the holes in the dash by using the mounting bracket
as a template. Drill the holes, then attach the mounting bracket using the
supplied 5 x 16 mm screws.
• Be sure to mount the transceiver in a location where the controls will be within
easy reach of the user and where there is sufficient space at the rear of the
transceiver for cable connections.
2 Connect the antenna and the supplied power cable to the transceiver.
3 Slide the transceiver into the mounting bracket and secure it using the
supplied hex-headed screws.
4 Mount the microphone hanger, using the supplied 4 x 16 mm screws, in a
location where it will be within easy reach of the user.
• The microphone should be mounted in a place where it will not interfere with
the safe operation of the vehicle.
5 Connect the microphone cable to the jack on the front panel of the
transceiver. Place the microphone on the hanger.
Microphone
hanger
Antenna
connector
Power input
connector
Mounting bracket
Transceiver
Power cable
Black wire
Microphone
Fuse holder
Red wire
Microphone cable
Hex headed
screw
Fuse
Battery
3