Programmable Functions - Kenwood TK-6110 Instruction Manual

The following functions can be programmed onto the
C▲, and SCN keys. Contact your dealer for details on these functions.
AUX
Press this key to turn the Aux output port ON (or OFF). When you press this
key, the AUX icon appears and a tone sounds. When you press this key
again, the icon disappears and a tone sounds.
CH 1 Direct/ CH 2 Direct/ CH 3 Direct/ CH 4 Direct/ CH 5 Direct
Press these keys to directly select the Channel 1, Channel 2, Channel 3,
Channel 4, or Channel 5 directory (respectively).
Channel Down
Press this key decrease the channel number by 1 step. Press and hold this
key to scroll down through the channels. Unprogrammed channels will be
skipped.
Channel Name
Press this key to switch the display between the Channel number and name
(alphanumeric). A tone will sound each time you press this key.
Channel Up
Press this key increase the channel number by 1 step. Press and hold this
key to scroll up through the channels. Unprogrammed channels will be
skipped.
Delete/ Add
Press this key to delete a channel from, or add a channel to, the scanning
sequence. If a channel is already added to the scanning sequence, and you
want to delete it, press this key while the channel is displayed. The channel
add icon disappears. If a channel is not added to the scanning sequence,
and you want to add it, press this key while the channel is displayed. The
channel add icon appears.
Press this key while scanning, when an undesired channel is displayed, to
temporarily delete it from scan. If there are only 2 channels in the scanning
sequence, this function cannot be performed. To restore the original scanning
sequence, turn the scan function OFF, then ON.
Emergency Call
Press and hold this key for approximately 2 seconds to initiate an emergency
call (requires the ANI board). When an emergency call is made, no tone is
emitted and the display does not change. To end the emergency call, turn the
transceiver power OFF.

PROGRAMMABLE FUNCTIONS

, , MON, A, B▼,
7