Installing The Transceiver; Dc Power Cable; Fuse (15 A); Mounting Bracket - Kenwood NEXEDGE NX-700 Instruction Manual

INSTALLING THE TRANSCEIVER

For passenger safety, install the transceiver securely using an optional mounting bracket and screw
set so the transceiver will not break loose in the event of a collision.
1 Mark the position of the holes in the dash by using the mounting bracket as a
template. Drill the holes, then attach the mounting bracket using self-tapping
screws.
• Be sure to mount the transceiver in a location where the controls are within easy
reach of the user and where there is suffi cient space at the rear of the transceiver for
cable connections.
2 Connect the antenna and power cable to the transceiver.
3 Slide the transceiver into the mounting bracket and secure it using
hex-headed screws.
4 Mount an optional microphone hanger in a location where it will be within easy
reach of the user.
• The optional microphone and microphone cable should be mounted in a location
where it will not interfere with the safe operation of the vehicle.
When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same value.
Never replace a fuse with a fuse that has a higher value.
Antenna
connector
Power input
connector
DC power
cable
Ignition
sense cable
Hex-headed
screws
External
speaker jack
Black (–) cable
Red (+) cable

Flat washer

Spring washer

Self-tapping screw
Optioinal
microphone
12 V vehicle
battery
Fuse
Mounting
bracket
3