Removing Anti-Freeze From The Unit - Prochem EVEREST 650 Operating Instructions Manual

Removing Anti-freeze From The Unit

1. Connect the water inlet hose to the water inlet
connection on the console. Turn the water supply
on.
2. Start the unit and turn on solution pump.
3. Connect all solution hoses and any tools that
require purging of anti-freeze to the solution outlet
connection(s).
4. Open the tool valves and drain the anti-freeze into
an approved container until the flow is clear and all
anti-freeze is purged from the tools and hoses.
86411100 Manual Operators - Everest E-Idle Prochem
5. Submerge the chemical inlet tube in water. Turn
the chemical valve to the PRIME position until clear
water is observed in the Flow meter.
6. Turn the chemical valve to the Run position and
turn Flow meter valve to vertical position. This will
allow water to flow into the other side of the
system.
High Pressure (Optional)
Close ball valve between chemical pump and solution
pump. Move pressure system valve to high-pressure
position. Open the tool valve and drain the antifreeze
into an approved container until the flow is clear and all
anti-freeze is purged from the tool and hose.
Once all of the anti-freeze is removed, the unit is ready
to use.
Eventually, the anti-freeze in your storage
container will become diluted with water. If the anti-
freeze level drops below 50% of the total, dispose
of it and start with fresh 100% anti-freeze.
When disposing of used anti-freeze, observe local
laws and regulations. Do not drain onto the ground
or into storm drainage systems.
Lors de l'élimination de l'antigel usé, respecter
toutes les lois et tous les règlements locaux. Ne
pas vider sur le sol ou dans des réseaux de collecte
des eaux pluviales.
Operations
43