Pre-Run Inspection / Setup; Water Supply Connection; High Pressure Solution Hose; Vacuum Hose - Prochem EVEREST 650 Operating Instructions Manual

Operations

Pre-run Inspection / Setup

NOTE: Operation of this unit is simple. However, only
trained personnel should proceed.
Operate this unit and equipment only in a well-
ventilated area. Exhaust fumes contain carbon
monoxide, which is an odorless and deadly poison
that can cause severe injury or fatality. DO NOT
operate this unit where the exhaust may enter any
building doorway, window, vent, or opening of any
type.
Utiliser cet appareil et cet équipement uniquement
dans un endroit bien ventilé. Les gaz d'échappe-
ment contiennent du monoxyde de carbone qui est
un gaz inodore et mortel pouvant causer des
blessures graves ou entraîner la mort. NE PAS faire
fonctionner cet appareil dans un endroit clos. NE
PAS utiliser cet appareil dans un endroit où les gaz
d'échappement risquent de pénétrer dans une
entrée de porte, une fenêtre, un évent ou toute
ouverture d'un édifice.
Check For Adequate Fuel
Check the fuel tank to be certain there is adequate fuel
to complete the job. This unit uses approximately 1.00
to 1.50 gallons of fuel per hour, depending on the
speed setting and vacuum load.
Remove Tools from Vehicle
Remove any tools or hoses from the van which you will
require.

Water Supply Connection

NOTE: Before connecting your water hose to the
supply faucet, flush out the faucet until the water is
free of any debris. Flush out any debris that may be in
your water inlet hose.
1. Connect the water supply hose to the water inlet
quick-connect at the left front of the console.
Connect the hose to the water supply faucet.
NOTE: Never use your waste pump outlet hose as a
water inlet hose. Use only clean hoses for water inlet.
2. Turn the water supply faucet on. The water will fill
the water box.
38 86411100 Manual Operators - Everest E-Idle Prochem
Don't run the solution pump dry, damage may
occur and void the warranty.
In the event the pump is run dry, allow the pump to
cool down to ambient temperature before reintro-
ducing water. Otherwise major damage may occur
and void the warranty.
Ne pas laisser la pompe à solution fonctionner à
sec, cela risquerait d'entraîner des dommages et
d'annuler la garantie.
Si la pompe venait qu'à fonctionner à sec, laisser
refroidir la pompe à température ambiante avant de
réintroduire de l'eau. Sinon, cela risquerait
d'entraîner des dommages et d'annuler la garantie.

High Pressure Solution Hose

Before starting the unit, connect the high-pressure
solution hose to the outlet connection at the front of the
unit. Connect the cleaning tool to the pressure hose.
DANGER
ROTATING
MACHINERY.
WATER UNDER
PRESSURE AT HIGH
TEMPERATURE.
IMPROPER
MODIFICATION OF
EQUIPTMENT CAN
CAUSE SEVERE
PERSONAL INJURY
WATER UNDER HIGH PRESSURE AT HIGH
OR COULD BE
TEMPERATURE CAN CAUSE BURNS,
FATAL.
SEVERE PERSONAL INJURY, OR COULD
BE FATAL. SHUT DOWN MACHINE,
ALLOW TO COOL DOWN, AND RELIEVE
SYSTEM OF ALL PRESSURE BEFORE
REMOVING VALVES, CAPS, PLUGS,
FITTINGS, FILTERS AND BOLTS.

Vacuum Hose

Connect the vacuum hose to the vacuum inlet connec-
tion at the front of the Filter Box. Connect the other end
of the vacuum hose to the cleaning tool.
Filters
Ensure all filters on machine and in waste tank are free
of debris.
DANGER
DO NOT MODIFY
UNIT WITHOUT
WRITTEN
PERMISSION
FROM
MANUFACTURER