Test Frequency; Analog Mode Signaling - Kenwood NX-5700 Service Manual

Key "Func" appears on the sub LCD display
Function
[ ] High power/Medium
power/Low power
[ ] Function off
[ ] Compander on/off
[ ] External Speaker on/off
[AUX Function off
(Orange)]
[PTT] Transmit
• LCD display in panel test mode
(Power ON)
Type
4.12.3 Frequency and Signaling
The transceiver has been adjusted for the frequencies shown in
the following table. When required, readjust them following the
adjustment procedure to obtain the frequencies you want in ac-
tual operation.

(1) Test frequency

CH RX (MHz)
1 155.05000 155.10000
2 136.05000 136.10000
3 173.95000 173.90000
4 155.00000 155.00000
5 155.20000 155.20000
6 155.40000 155.40000
7~16 - -
1-64 (No.RA020<Rev.002>)
Display
High: "H"
Medium: "M"
Low: "L"
-
On: icon appears
On: icon appears
-
-
Sub LCD display
Main LCD display
(After 2sec.)
Frequency range
136~174MHz
TX (MHz)
Key "Func" appears on the sub LCD display
[0] to [9] Function off
and
[#], [ ]
*3: When the mode is selected as P25, this function is enabled.
• LED indicator
Red LED Lights during transmission.
Green LED Lights when there is carrier.
• Sub LCD indicator
"Func" Appears at function on.
Temperature
Power
An : Analog narrow mode
Aw : Analog wide 5k mode
As : Analog wide 4k mode
P1 : P25 Phase1 mode
P2 : P25 Phase2 mode
Nn : NXDN narrow mode
Nv : NXDN very narrow mode
(2) Test signaling
Analog mode signaling
No.
1 None
2 None
3 LTR Data
4 QT:67.0Hz
5 QT:151.4Hz
6 QT:210.7Hz
7 QT:254.1Hz
8 DQT:D023N
9 DQT:D754I
10 DTMF Decode
(CODE: 159D)
11 None
12 2-tone Decode
(A: 304.7Hz, B: 3106.0Hz)
13 Single Tone Decode
(979.9Hz)
Function
-
Signaling
No.
Channel No.
Squelch level
(Analog mode only)
RX
None
Square Wave
LTR Data
QT:67.0Hz
QT:151.4Hz
QT:210.7Hz
QT:254.1Hz
DQT:D023N
DQT:D754I
DTMF Encode
(CODE: 159D)
DTMF Encode (CODE: 9)
2-tone Encode (A: 304.7Hz,
B: 3106.0Hz)
Single Tone Encode
(979.9Hz)
Display
TX