Kenwood NX-5700 Service Manual page 47

Item Condition
Panel tuning
mode
4. *The Frequen- 1) Adj item:
Frequency cy adjust- [Frequency]
ment can be SSG output:
performed -20dBm (22.4mV)
only in PC (CW (without mod-
test mode. ulation))
Caution:
Perform
quency adjustment
under the following
conditions.
• Temperature range
of +20°C to +33°C
(+68.0°F to
+91.4°F).
(The temperature is
displayed on the
Frequency adjust-
ment screen of the
KPG-D1/D1N and
the LCD of the
transceiver.)
• Use an accuracy of
0.003ppm for the
SSG. (Use a stan-
dard oscillator if
necessary.)
5. 1) Adj item: 1) Adj item:
RTC [RTC] [RTC Correction]
Corre- Adjust:[****] Data: {****]
citon Press [ ] key Press [Apply] button
to store the ad- to store the adjust-
justment val- ment value.
ue.
Measurement
PC test mode Test-
equip-
ment
SSG Panel ANT
the fre-
Fre- Panel
quency
Counter
Adjustment
Unit Ter- Unit Parts
minal
Panel [Panel
tuning
mode]
[],
[]
[PC
test
mode]
[←],
[→]
TEST [Panel
POINT
tuning
(CN715)
mode]
[], []
[PC test
mode]
[←], [→]
Specifications
Method
[PC test mode] [PC test mode]
Press [Start] button of "IF20" value = With-
"Auto Tuning". in 0±10 digits. The
Press [Apply] button to value of "IF20" will
store the adjustment become around "0"
value after the automatic after the adjustment
adjustment has has finished.
finished.
Remark:
"Frequency" is
adjusted under
receiving condition
with SSG.
[Panel tuning mode] Remaks:
Press [ ] key to store Change the adjust-
the adjustment value. ment value so that
[PC test mode] the frequency cur-
Press [Apply] button to rently displayed on
store the adjustment "Crystal Oscillation
value. Frequency" on the
PC window and the
frequency currently
displayed on the
frequency counter
are in agreement.
(No.RA020<Rev.002>)1-47
/Remarks