Install the SAS controller
Power down the server blade (on page 12).
1.
Remove the server blade (on page 13).
2.
Remove the access panel (on page 14).
3.
Disconnect the FBWC battery pack cabling, if connected
4.
46).
IMPORTANT:
Close the SAS controller handle and then install the SAS controller. To properly seat the SAS controller,
5.
press firmly in the areas indicated on the SAS controller.
Remove the front panel/drive cage assembly
Power down the server blade (on page 12).
1.
Remove the server blade (on page 13).
2.
Remove the access panel (on page 14).
3.
Disconnect the capacitor pack cabling, if connected
4.
Remove the SAS controller (on page 14).
5.
CAUTION:
assembly.
Extend the serial label pull tab from the front of the server blade.
6.
Remove the two T-15 screws from the front panel/drive cage assembly.
7.
Always close the SAS controller handle before installing the SAS controller.
Always remove the SAS controller before removing the front panel/drive cage
("FBWC capacitor pack
("FBWC capacitor pack
cabling" on page
cabling" on page 46).
Operations 15