Page 1
OWNERS AND SERVICE MANUAL INNOVATIVE CONCEPTS IN ENTERTAINMENT INC. 10123 MAIN STREET, CLARENCE, NY 14031 SERVICE: 1-716-759-0360 FAX: 1-716-759-0884 E-MAIL: service@icegame.com WEBSITE: www.icegame.com...
TABLE OF CONTENTS Safety & Warnings Game Introduction and Game play Games Setup Access to Program Settings Access to Meters Adjusting volume Program Setting Information Program Setting Examples Card swipe Installation Game Maintenance Marquee Removal Control Panel Removal Monitor Power Supply Removal AC Information PC Removal Restore Instructions...
SAFETY AND WARNINGS BEFORE YOU BEGIN WARNING: WHEN INSTALLING THIS GAME, A GROUNDED A.C. RECEPTACLE MUST BE USED. FAILURE TO DO SO COULD RESULT IN INJURY TO YOURSELF OR OTHERS. FAILURE TO USE A GROUNDED RE- CEPTACLE COULD ALSO CAUSE IMPROPER GAME OPERATION, OR DAMAGE TO THE ELECTRONICS. DO NOT DEFEAT OR REMOVE THE GROUNDING PRONG ON THE POWER CORD FOR THE SAME REA- SON AS GIVEN ABOVE.
Game Introduction 30 years has passed since Frogger’s first release back in 1981. It is one of the most popular and recognizable video games ever made. Frogger has returned as a video redemption game. This two player interactive kid’s game has quick coin game appeal and collections to back it up! Combined with the very best video technology and graphics on a 42”...
Game Setup Access to the Program Settings: Located in the upper coin door are the programming buttons. To access the program settings press “test” button. Press the VOL with the arrow up button to move the cursor up and press the VOL with the arrow down button to move the cursor down.
Page 6
Game Setup Programming Version .89 Main Menu: Diagnostics Switch Test Tests various switches used in the game. Dip Switch Test Shows current dip switch settings on I/O board. Monitor Test Shows various screens to test your monitor. Lamp Test Marquee Lamps (Fireflies) Turns on and off fireflies pcb boards.
Game Setup Programming Continued Main Menu: Coin Adjustments Free Play Off/On Coin Lockout Off/On Currency Type Coin/Dollars/Swipe Coins Coin Value 0.250 0.250 Coins to play Frogs per game Coins per swipe Payout Adjustments Ticket use Off/On Fixed tickets Off/On Fixed tickets per frog Payout percent 20-80 by 5 % increments Ticket Value Minimum tickets 1...
Game Setup Card Swipe Installation Example There are many card swipe systems available today. The following information is general and you should refer to your installation instructions that has been included with your card swipe system for specific details. If your game was not ordered with blank coin doors then you can order replacement blank coin doors from our Service Department.
Game Maintenance Marquee Removal Remove both the upper and lower back doors and put aside. Unplug the 6 pin, 4 pin and A/C har- nesses located in the upper section of the cabinet. Remove the four mounting bolt, washers and nuts.
Game Maintenance Monitor Power supply Removal The monitor uses a 24 volt DC power supply at 13 amps. It is located in the back of the game. To access remove the back door and put aside. The power supply is mounted on the wall on the left side.
Page 11
Game Maintenance PC Access and Removal The PC is located behind the circuit board. The circuit board and PC are mounted onto the back drawer assembly. Remove the lower back cabinet door. At the bottom of the cabinet and underneath the cir- cuit boards is a large thumb screw .
Game Maintenance Podium Removal *** WARNING ** With the removal of the podiums the main cabinet will become top heavy and fall for- ward damaging the monitor assembly and possibly cause bodily injury. It is recommended to have two or more people available to prevent the main cabinet from falling forward. It might become necessary to remove the front podiums from the main cabinet in order to fit the game through some doors.
Game Maintenance Marquee Bonus Ticket Display Assembly Removal To remove the bonus ticket display assembly remove the four mounting bolts that hold it to the marquee cover. This is only required if you need to replace the front plastic or lens. It is not necessary to remove the entire assembly to replace the dis- play board.
Game Maintenance Marquee Cover Removal In order to replace the either the Firefly lights or the PLL bulbs used in the marquee of the game, it is necessary to remove the front marquee graphic. The marquee is held attached to the cabinet by 4 bolts with nuts. Once removed, the marquee cover lifts up and out.
Game Repair CAUTION This game uses complex electronic components that are very sensitive to static electricity. Observe precau- tions below before handling these electronics. Failure to do so may void the warranty and damage electronic assemblies. Before servicing electronics, turn off AC power to the game. Wait for capacitors to discharge. DO NOT remove any of the components on the PCBA boards (e.g.
WARRANTY POLICY I.C.E. Inc warrants all components in new machines to be free of defects in materials and workmanship for the period listed below: ■ 180 days on Main PCB’s, Computers & Motors ■ 1 year on all LCD monitor panels ■...