Unpacking And Set-Up - STRILING Shuttle ULT25NE Operating Manual

7.
Notes on operation in a vehicle.
A. The freezer will operate on vehicle battery power for a limited time before
the battery is drained and the motor vehicle cannot be started. This time will
vary from vehicle to vehicle but is generally only a few hours.
B. The vehicle engine should be running to prevent accidental total discharge
of the battery.
C. The power to 12V outlets in some vehicles may be interrupted during
engine starting. This will cause a sudden stop of the cooling unit which may
produce a sound that is different than when turning off the freezer by using
the On/Off button. This is normal and will not damage the cooling engine.
The cooling engine will restart automatically once power resumes.
D. 20 A DC REQUIREMENT: Please note that 20 A DC service is required for
proper functioning of the freezer in a motor vehicle. Some vehicles may not
be equipped with 20 A DC service. Consult your automotive specialist to
verify the level of DC service installed in your vehicle.
E. Do not operate the freezer in an unattended vehicle. This may lead to
overheating if left in the sun and subsequent damage to stored contents.
8.
Disconnecting from power.
A. Turn off the freezer (Press and hold On/Off button for three beeps).
i. The LCD display will show the word "OFF" while the Shuttle
turns off.
ii. Unplug the freezer after the word "OFF" disappears and the
display goes dark.
iii. If you unplug the freezer while it is on, you will hear a sudden noise
as the free-piston Stirling engine shuts off. Power outages will also
cause the same noise. This noise (described as a "bonk") is not
indicative of damage.
Operating Manual: 10327.1 | 12.22.2016
ULT25NE

2. Unpacking and Set-up

www.stirlingultracold.com 9 of 28