STRILING Shuttle ULT25NE Operating Manual page 15

To change the Setpoint by Method A
•
— Press and hold the Set Temp button and then push the
release the Set Temp button).
– The Setpoint temperature will appear with the prefix S in the
LCD display.
– When the
1 º C at first.
– If the
increase/decrease by 5 º C.
– If the
while continuing to hold down the Set Temp button the increment/
decrement size will return to 1 º C.
– Release all buttons once the desired Setpoint is achieved. The display
will return to chamber temperature after about eight seconds.
To change the Setpoint by Method B
•
— Press and hold the Set Temp button until the Set Temp LED glows.
– The Setpoint temperature will appear with the letter S in the first
LCD display.
/
— The
– When the
by 1 º C at first.
– If the
increase to 5 º C.
– Briefly release (a half second) the
to hold down the Set Temp button the increment/decrement size will
return to 1 º C.
– Release the
— Press the Set Temp button briefly (less than one second) to turn off the
Set Temp LED. The display will return to chamber temperature.
Operating Manual:
/ buttons are first pushed the Setpoint will change by
/ buttons are held for five seconds the step size will
/ buttons are briefly released (less than a half second)
buttons can be used to change the Setpoint.
/ buttons are pushed the Setpoint will change
/ buttons are held for five seconds the step size will
/ buttons once the desired Setpoint is achieved.
ULT25NE
4. Operation
/ buttons while continuing
10327.1 | 12.22.2016
/ buttons (do not
www.stirlingultracold.com 15 of 28