STRILING Shuttle ULT25NE Operating Manual page 3

Initial Setup
Port Stopper/Sealant
Power Indicator
Power ON
Power OFF
LCD Display
Display Setpoint
Return to Temp Display
Change Setpoint
Advanced Functions
Change to Preset
Postpone Over Temp Alarm
Return to Temp Display
See Error Code Again
Lock Panel
Unlock Panel
LCD Display Codes
A
B
Notice:
When unit is first turned on, red Over Temp LED (I) will be on until
temperature is within 10 º of setpoint.
Panel cannot be locked until temperature is within 10 º of setpoint.
Operating Manual:
25N
E
ULT
The Port Stopper/Sealant must be in place during operation.
!
Remove tape at port stopper prior to initial use.
A
The Shuttle is ON when lit
B
Press and hold for two beeps
B
Press and hold for three beeps
C
Displays chamber temperature, S ## – setpoint
F
Press/Release to display current setpoint
Press/Release or wait eight seconds
F
Press and hold until Set T LED (E) glows, S ## displayed,
F
(D)
then or
Press and hold Set (F) until Set T LED (E) glows, S ## displayed,
then select Preset 1, 2 or 3 (J)
When Over Temp LED (I) glows, press Preset 3 (J) until time shows
(1.0 h) (If Over Temp LED is not glowing, then Preset 3 acts as a
Temp Preset)
Wait eight seconds, press Preset 3 to return to temperature display
If Error LED (H) is glowing, press Preset 2 (J) briefly
(If Error LED is not glowing, then Preset 2 becomes Temp Preset)
Press and hold Preset 1 AND 2 AND 3 (J) until Locked LED (G) turns
on (~five seconds)
Press and hold Preset 1 AND 2 AND 3 (J) until Locked LED (G) turns
off (~five seconds)
P ## – Preset Temp, ## h – Alarm Silenced, E ## – Error Code
(see operating manual)
C
D
ULT25NE 10327.1 | 12.22.2016
Quick Guide
E G H
F J
www.stirlingultracold.com
I
3 of 28