4. Other
4.4.20
Aligning section
1. Remove the finisher unit left front cover.
See P.26
2. Remove the finisher unit rear cover.
See P.26
3. Remove the finisher unit upper cover.
See P.27
4. Remove the exit transportation section (upper) assy.
See P.38
5. Remove the exit lower roller assy.
See P.46
[4]
[2]
[5]
[2]
[1]
54
[3]
[1]
9J08F2C538DA
9J08F2C010DA
Service Manual
Field Service Ver. 3.0 Jan. 2008
6. Remove two screws [1] and remove
the ground wire.
7. Remove two screws [2].
8. Remove the wire saddle [3] and dis-
connect two connectors [4], and
remove the exit paddle drive clutch
mounting plate assy [5].
9. Remove the screw [1] and remove
the connector cover [2].
Y108442-7