Table of Contents
Advertisement
Specifications
Batteries
Technology: Nickel-metal-hydride (NiMH); Size: AAA (Micro, HR03); Voltage: 1.2 V; Capacity: 400 - 1000 mAh
General specifications
DECT standard
GAP standard
Range
Base station power supply
Radio frequency range
Transmission power
Environmental conditions in operation
Base station power consumption
In standby mode
– Handset in base station
– Handset outside base station
During a call
Questions and answers
If you have any queries about the use of your telephone, visit our website at www.gigaset.com/service for 24-hour sup-
port. The table below contains a list of common problems and possible solutions.
Problem
Nothing appears in
the display.
No wireless connec-
tion to the base sta-
tion, Base flashes in
the display.
You cannot hear a
ringer/dialling tone
from the fixed line
network.
Error tone sounds
after system PIN
prompt.
PIN forgotten.
Contact with liquid
If the handset has come into contact with liquid:
1
Switch off the handset and remove the battery pack immediately.
2
Allow the liquid to drain from the handset.
3
Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry,
warm place for at least 72 hours (not in a microwave, oven etc.).
4
Do not switch on the handset again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
Cause
The handset is not switched on.
The batteries are flat.
The handset is outside the range of the
base station.
The handset is not registered.
The base station is not turned on.
The phone cord supplied has not been
used or has been replaced by a new cord
with the wrong jack connections.
The system PIN you have entered is
incorrect.
!
12
is supported
is supported
up to 300 m outdoors, up to 50 m indoors
230 V ~/50 Hz
1880-1900 MHz
10 mW average power per channel, 250 mW pulse power
+5 °C to +45 °C, 20% to 75% relative humidity
A120/A220
A120A/A220A
ca. 1.0 W
ca. 1.2 W
ca. 0.8 W
ca. 1.0 W
ca. 1.0 W
ca. 1.2 W
Solution
Press the end call key
place the handset in the base station.
Charge or replace the batteries.
Move the handset closer to the base station.
Register the handset
Check the mains connector on the base station
¢
page 3.
Please always use the phone cord supplied or ensure
that the pin connections are correct when purchas-
ing from a retailer: 3-4 assignment of telephone
leads/EURO CTR37.
Reset the system PIN to the default 0000
All handsets are de-registered. All settings are
reset. All lists are deleted.
a
for approx. 5 seconds or
¢
page 9.
¢
page 10.
Advertisement
Table of Contents
