Half-Width Servers With Dual-Port Cnas - Dell PowerEdge FX2 Configuration Manual

D.2

Half-width servers with dual-port CNAs

The PowerEdge FC630 is an example of a half-width server. For half-width servers with dual-port CNAs
installed, the CNA ports map to a single port on each of the two FN IOMs. Figure 12 and Table 2 present the
port mapping for half-width servers with dual-port CNAs.
Note: Ports 2, 4, 6 and 8 are not used when using half-width blades with dual-port adapters.
Half-width servers with dual-port CNAs
Server Slot
1
2
3
4
20 PowerEdge FX2 - Upgrading from 10GbE Pass-through Modules to FN410S I/O Modules | version 1.0
Slot 1
Slot 3
FN IOM A1 (Top)
Internal Ports
1 2 3
5 6 7
Half-width servers with dual-port CNAs
FN IOM A1 (Top)
Internal Port Numbers
1
3
5
7
4
FN IOM A2 (Bottom)
8
Internal Ports
1 2
5 6
FN IOM A2 (Bottom)
Internal Port Numbers
1
3
5
7
Slot 2
Slot 4
3 4
7 8