Initial Printer Setup; Setup By 3D Platform Technician Or Certified Service Provider (Csp); Gantry Setup - 3D Platform WorkSeries 200 Series User Manual

3D Platform WorkSeries 200, 300 & 400 Manual Revision: C
Date: December 28, 2017

Initial Printer Setup

Setup by 3D Platform Technician or Certified
Service Provider (CSP)
Most customers choose to have a 3D Platform factory
technician or a CSP complete the initial setup and
training. Please do not proceed with setup if this
option was purchased.
This option is compulsory inside of
the European Union (EU).

Gantry Setup

The machine ships with the gantry folded down for
portability during shipping and installation. To set up,
use a 4-mm hex wrench to loosen the four 5 mm screws
on the YZ carriages (eight screws total). Once screws are
removed, the gantry will pivot on center of the
carriages. Have an assistant hold onto the gantry while
pivoting to the upright position, then re-install and re-
tighten 5 mm screws. Ensure two gantry carriages are
square while reinstalling for best alignment.
12
3dplatform.com • 3DP-DOC-005 (12-2017)