Table of Contents
Advertisement
3D Platform
Introduction
This quick start guide introduces the basic controls and functionality provided with the WorkSeries controller. This
reference guide is meant only as a secondary reference. This guide should be used in conjunction with the 3D Platform
WorkSeries User Manual, which can be downloaded from our website at www.3dplatform.com.
G-Code Console Operation
From the Touch Screen
1. Select the "Console" tab at the bottom of the touch screen.
2. Select the keyboard symbol at the top of the touch screen.
3. Type in the g-code or m-code you wish to execute.
4. Press the enter key on the touch screen keyboard.
5. Read the feedback message corresponding to the command executed (if applicable).
6. Verify the result corresponds to the expected result of the command sent.
From the Web Interface
1. Locate the "G-Code Console" at the left side of the web interface.
2. Type the command to be executed into the command line and press enter.
3. Read the feedback message corresponding to the command executed (if applicable).
4. Verify the result corresponds to the expected result of the command sent.
Note: For a list of g-codes and m-codes supported by our controller refer to our support page at support.3dplatform.com.
Wi-Fi Setup
Wi-Fi Connection Setup
1. With the control box turned on, select the "Console" tab on the touch screen.
2. Select the keyboard symbol at the top of the touch screen.
3. Type
M552 S0
into the keyboard to turn off Wi-Fi connection.
4. Press the Enter symbol to run the command (Repeat this step for following commands).
5. Type
M552 S1
into the keyboard to turn on Wi-Fi connection.
6. On your computer or mobile device, open the Wi-Fi (network) connections list.
7. Select "Duet Wi-Fi" and connect.
Note: If network does not appear, enter M552 S2 in Console on touch screen.
8. Open a web browser and type the IP address 0.0.0.0 into the browser bar.
Note: If 0.0.0.0 does not work, try 192.168.1.1
9. In the menu, select your local Wi-Fi network and enter the network password.
10. You should receive an "All Done!" message.
11. Disconnect your PC or mobile device from the "Duet Wi-Fi" network.
12. Power cycle the controller to complete the setup (Black Button, followed by Green Button).
3DP-DOC-006 (11-2017)
WorkSeries Quick Reference Guide
www.3dplatform.com
Revision: B
Date: November 13, 2017
pg. 2 of 8
Advertisement
Table of Contents
