Westinghouse WWF1274 User Manual page 26

26
Malfunction
There is water
on the floor:
Unsatisfactory
washing
results:
The door will
not open:
The machine
vibrates or is
noisy:
Cycle time
longer than
displayed:
Possible cause
Too much detergent or unsuit-
able detergent (creates too
much foam) has been used.
Check whether there are any
leaks from one of the inlet
hose fittings. It is not always
easy to see this as the water
runs down the hose; check to
see if it is damp.
The drain hose is damaged.
Too little detergent or unsuit-
able detergent has been used.
Stubborn stains have not been
treated prior to washing.
The correct temperature was
not selected.
Excessive laundry load.
The program is still running.
There is water in the drum.
In case of power failed, the
door cannot be open.
The transit bolts and packing
have not been removed.
The support feet have not
been adjusted.
The laundry is not evenly
distributed in the drum.
There is very little laundry in
the drum.
Unstable floors eg. wooden
floors.
Detergent over dose.
Machine unbalance.
Solution
Reduce the detergent
quantity or use another one.
Check the water inlet hose
connection.
Please call Service Center.
Increase the detergent
quantity or use another one.
Use commercial products
to treat the stubborn stains.
Check if you have selected
the correct temperature.
Reduce load.
Wait until the end of washing
cycle.
Select "Drain & Spin" option
to empty out the water.
Please wait until the power
resume. But, if you really
need to open it, please call
Service Center.
Check the correct
installation of the appliance.
Check the correct levelling
of the appliance.
Pause the machine and
redistribute laundry manually.
Load more laundry.
Refer to relevant paragraph
in "Positioning" section.
Reduce the detergent
quantity or use another one.
Redistribute laundry manually in
the drum and start the spin
phase again. Refer to relevant
paragraph in "Positioning"
section.