Inspection/Check/Maintenance Schedule - Hobart Jet-Ex 5D Operation And Maintenance Manual

OM-2094 / Operation and Maintenance Manual
Jet-Ex 5D / Series 500285 / Generator Set
Recommended Service Intervals
Engine
Check oil level
Check coolant level
Check fuel quantity
Check gages and instruments for proper operation
Drain Fuel Pre-Filter Element
Change engine oil
Change oil filter
Check and tighten drive belts
Clean and inspect exterior of radiator
Check exhaust system
Check cooling system concentration
Atomizer Maintenance
Replace fuel filter
Clean engine
Check valve tip clearance, adjust if necessary
Electrical System (12V DC)
Check lights
Check charging rate
Check battery state of charge (alternator)
Check wiring and connections
Check starter motor
Check battery terminals and connectors
Electrical system (28.5V DC)
Check indicating light
Check operation of all instruments, meters, etc.
Check generator brushes for length, cleanliness
and free operation
Check slip rings for smoothness and cleanliness
Check the entire unit
Check overvoltage protection
Check all wiring connections
Trailer (500285-001 only)
Lubricate
Check tire inflation
Check and adjust wheel bearings
Lubricate wheel bearings
Check brake tension
Chapter 2-1
Page 2
Service

Inspection/Check/Maintenance Schedule

Figure 1
8 hrs.
or
First
Daily 250 hrs.
or
at
6 Months
20/40
Hrs
X
X
X
X
X
X X
X X
X X
X X
X
X
X
X
X
X
X
X
X
X
500 hrs.
or 2000
12 Hours
Months
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
November 1, 2000
Revised 03/01