Preparation For Storage; Preparation For Shipping; Temporary Storage; Long Time Storage - Hobart Jet-Ex 5D Operation And Maintenance Manual

OM-2094 / Operation and Maintenance Manual
Jet-Ex 5D / Series 500285 / Generator Set
·
Tighten the cable clamp and install the lower panel, and the door.
·
Store cables in cable tray or on hangers on side of canopy if fenders are not used.

Preparation for Storage

2.
When a generator set is to be stored or removed from operation, special precautions should be taken
to protect the internal and external parts from rust and corrosion.
a. General
The unit should be prepared for storage as soon as possible after being removed from service.
Storage should be in a building which is dry and which may be heated during winter months.
b. Temporary Storage
When storing the unit for one month, prepare as follows:
(1) Lubricate the unit completely in accordance with instructions in Section 2-2; Para. 2. This will
include changing engine oil, and filter elements.
(2) Make certain the cooling system antifreeze solution is adequate to protect below the lowest
temperatures expected during the storage period.
(3) Clean the exterior of the engine with fuel oil and dry with clean cloths and compressed air.
(4) Seal all engine openings. Use a vapor and waterproof proof material that is strong enough to
resist puncture damage from air pressure.
c. Long Time Storage
(1) Engine Protection
The Jet-Ex 5D generator set may be stored for long periods if the engine is given proper
protection from rust and corrosion. Refer to the Engine Manufactures Users Handbook for proper
procedures to be followed.
(2) Generator Protection
To protect the generator and other electrical components, the complete unit should be
packaged, using moisture proof packaging and sealing materials. Place packages of moisture
absorbing chemicals, such as silica-gel, in the unit before packaging.
(3) Battery Care
Remove battery and store in a cool dry place. Store the battery on wood rather than directly on
cement or metal.

Preparation for Shipping

3.
Prepare the unit for shipping as follows:
·
Disconnect battery cables.
·
Seal all engine openings to prevent the entrance of water, dirt, and dust.
·
Drain all fuel from tank and fuel lines as required by carrier rules.
·
Crate the unit solidly to prevent damage to instruments, glass, and sheet metal.
November 1, 2000 Chapter 1-2
Page 3