Operation - RedMax G3800AVS Owner's/Operator's Manual

7. Operation

F7
F8
F9
F10
F11
12 
WARNING
It is very dangerous to run a chainsaw that
mounts broken parts or lacks any parts.
Before starting engine, make sure that all the
parts including bar and chain are installed
properly.
■ STARTING ENGINE
1. Fill fuel and chain oil tanks respectively, and
tighten the caps securely. (F7)
2. Put the switch to "I" position. (F8)
(1) Chain oil
(4) Throttle lever (5) Throttle interlock
3. Pull out the choke knob to the second-stage
position. The choke will close and the throttle
lever will then be set in the starting position
[F10-(a)].
(6) Choke knob
NOTE
When restarting immediately after stopping the
engin, Choke knob in the first-stage position (choke
open and throttle lever in the starting position)
NOTE
Once the choke knob has been pulled out, it will
not return to the operating position even if you
press down on it with your finger. When you wish
to return the choke knob to the operating position,
pull out the throttle lever instead.
4. While holding the saw unit securely on the
ground, pull the starter rope vigorously. (F11)
WARNING
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch
your body. It's very dangerous.
5. When engine has ignited first, puch in the choke
knob to the first-stage position and pull the
starter again to start the engine.
6. Allow the engine to warm up with the throttle
lever pulled slightly.
(2) Fuel (3) Switch