Sanyo SAP-K161GJA Technical & Service Manual page 84

Air Cleaning Filter
(hot provided)
NOTE
How to install the air
cleaning filter
NOTE
Cleaning the main unit and
remote controle unit
Removing and remounting
the air intake grille
Washing the grille with
22
Care and Cleaning (continued)
The air cleaning filter removes dust and dirt from the air, and reduces odors
and smoke from tobacco.
The air clean filter is not provided with the air conditioner and must be
purchased separately.
Ask for the STK-F4B model when purchasing.
This air cleaning filter cannot remove harmful gases or vapors nor
ventilate air in the room. You must open doors or windows frequently
when you use gas or oil heating appliances. Otherwise there is a risk of
suffocation in extreme cases.
The air cleaning filter needs to
be installed behind the anti-mold
filter.
1. Remove the anti-mold filter.
2. To mount the STK-F4B, set
the air clean filter(sold
separately) at the mounting
position with the black side
facing the rear.
3. Reinstall the anti-mold filter,
and close the suction grill.
Dirty air clean filters cannot be washed and reused. Purchase a replacement
filter at your local dealer.
• Wipe clean using a soft, dry cloth.
• To remove stubborn dirt, moisten a cloth in warm water no hotter than
40°C, wring thoroughly, and then wipe.
• The air intake grille can be removed in order to wash it with water.
With the air intake grille open all
the way, grip both arms with your
hands and pull toward you to
remove. To remount, hold the air
intake grille roughly horizontal
and push it in until the arm shafts
fit into the indentations in the
main unit, then fit the grille into
place.
When using a footstool or the like, be careful not to let it tip over.
• Clean the grille gently using a soft sponge, or the like. Then wipe away
water any remaining moisture.
• Neutral detergent may be used to remove stubborn dirt. Then rinse
thoroughly with water and wipe away any remaining moisture.
Air clean filter
Air intake grille
Arm
OI-379-22EG