Sanyo SAP-K161GJA Technical & Service Manual page 73

Mounting the Remote
Control Unit
OI-379-11EG
Using the Remote Control Unit (continued)
Truss-head
tapping screws
× 16mm (supplied)
4
Remote
control
unit holder
When attaching to wall
1) Comfirm the indoor unit beeps when the ON/OFF button is pressed at the
wall location where the remote control unit is to be attached, then attach
the holder to the wall.
2) When taking out the remote control unit, pull it from the holder.
When using the remote control unit
• Point the transmission portion of the remote control unit at the receiver
area of the indoor unit when operating the remote control unit, and during
operation of the air conditioner.
• Do not place objects which may block the transmitted signals between
the receiver and the remote control unit.
Truss-head
tapping screws
4 × 16mm (supplied)
Holder
When Mounting the Remote Control Unit to Prevent Theft
1) Attach the holder to the wall with one of the screws (using only the hole
in the top of the holder).
2) Remove the cover of the remote control unit and take out the batteries.
Next, place the remote control unit in the holder.
3) Fasten both the remote control unit and holder to the wall with the
remaining screw (using the hole in the bottom of the holder).
4) Install the batteries in the remote control unit and close the cover.
Holder
11