Table of Contents
Advertisement
TROUBLESHOOTING
TIPS
NO
POWER
•
Check to make sure it is plugged
into an operating
outlet.
Check to make sure your connections
are correct.
VCR DOES NOT
RESPOND
TO REMOTE
•
Check to make sure there are no objects between the VCR and
remote.
•
The batteries
may need changing.
Make sure the Remote VCR1NCR2 setting
is set to VCR1 so the
remote that came packed with your VCR can operate
it.
POOR
OR NO PICTURE
FOR NORMAL
TV VIEWING
•
Check to make sure the VCR indicator
is off.
•
Check to make sure the TV is switched to an active channel.
•
Check to make sure the antenna connections
are secure and correct.
SNOWY
OR NO PICTURE
DURING
PLAYBACK
•
Press TV.VCR to turn VCR indicator
on,
Check TV channel selected (3 or 4) to make sure it matches the
channel selected with 3 CH. 4 switch on back of VCR.
•
Check to make sure the TV's fine tuning is correct for the channel
you have selected.
•
Check video cable connections
between VCR and TV monitor.
Check to make sure the TV monitor
is set to Video Input
(see page 68 for more information).
•
Try another tape.
Some snow/streaks
are normal during search, stop action, frame
advance, and slow-motion
playback.
STREAKS
IN PICTURE
DURING
NORMAL
PLAYBACK
•
Press one of the TRACKING buttons to move streaks up or down for
the best picture.
Check to make sure the tape is of good quality
and not worn out.
TIME
COUNTER
NOT WORKING
OR TIME
COUNTER
NOT
WORKING
IN SEARCH MODES
The time counter
does not advance during
unrecorded
portions
of
tape. When an unrecorded
segment of tape is encountered,
the
time counter will hold its count until recorded material
is detected
again.
A minus (-) will appear in front of the time if you rewind the tape
farther
back than a counter reading of 0:00:00.
•
The time counter disappears during
search; this is normal.
63
Advertisement
Table of Contents
