Table of Contents
Advertisement
7.4 Status
This page shows the current status of the touch panel.
7.5 IP Settings
Use this page to set the communication parameters for your touch panel. The touch panel uses standard internet protocol
(IP) communication parameters. You can reset certain parameters. On start up, this page will display the current IP address.
Carefully note this address information (and any changes you elect to make to the IP address, subnet mask, or default
gateway). Enter this information into the ControlBridge Builder program written for your specific application. For control
systems with more than one unit, a unique IP address must be given to each ControlBridge unit.
Select the appropriate field using the Edit button and then use the numeric keypad.
Be sure to click the Apply button for any changes to become effective.
Figure 7-3. Status screen.
192.168.1.128
255.255.255.0
192.168.1.1
Figure 7-4. IP settings screen.
877-877-2269 | blackbox.com
Chapter 7: On-Screen Display
Page 19
Advertisement
Table of Contents
