Table of Contents
Advertisement
Chapter 3: Installation
3. Installation
3.1 Mounting
Desktop models can be placed on any flat surface. To install, follow these steps:
1. Don't forget to prepare the proper bushing for the cable including a standard connector. The bushing should have a
minimum diameter of approximately 20 mm for the Ethernet connector.
2. Install the network cable as described on the following picture and connect the network connector.
Figure 3-1. Connecting the ControlBridge WIred Touch Panel to the network.
3. Place the touch panel on a table.
3.2 Cleaning the Touch Panel
Clean the touch panel screen overlay after each day's use.
You will need:
1 Two clean, soft texture cloths (cotton).
2. Spray bottle of cleaning solution without alcohol (window cleaner).
3. Clean aluminium parts using a special cleaning solution.
Follow these steps:
1. Turn the touch panel off.
2. Spray a small amount of the cleaning solution onto one of the cloths.
3. Clean the touch panel overlay with the damp cloth.
4. Wipe the touch panel overlay with the dry cloth.
Page 10
877-877-2269 | blackbox.com
Network cable
Network connector
Advertisement
Table of Contents
