Unpacking The Speakers; Inserting Batteries Into Remote Control; Set Up And Maintenance Of The Receiver; Protect Your Components From Overheating - RCA RT2350 User Manual

Unpacking The Speakers

• one set of speakers including 2 front speakers, 1
centre speaker, 1 subwoofer and 2 rear speakers.
• 6 speaker wires including:
1 X green/black wire
for center speaker
1 X white/black wire for
front left speaker
1 X blue/black wire for
rear left speaker

Inserting Batteries into Remote Control

Insert two AA(R6) batteries according to the + and -
signs on the battery compartment. To use the remote
control, point it directly at your receiver. Whenever a
button is pressed, a red indicator will light up on the
remote control.
Install batteries as follows:
1. Remove battery compartment door by applying
thumb pressure on battery door and then lift the
door out and off the cabinet.
2. Insert 2 AA batteries in the compartment and
replace the compartment door.
1 X red/black wire for
front right speaker
1 X purple/black wire
for subwoofer
1 X gray/black wire for
rear right speaker
Getting Started

Set up and Maintenance of the Receiver

• Provide spaces for sufficient ventilation as
indicated:
H O M E T H E A T E R A U D I O V I D E O R E C E I V E R
10 cm/
ON/STANDBY
4"
SOURCE
MUTE FM/AM TUNING MEMORY
SOURCE
PHONES
5 cm/
2"
• Do not connect to the AC power cords until all
connections are completed.
• Do not use your set immediately after transferring
it from a cold place to a warm place: there is risk of
condensation.
• Do not expose your set to water and excessively
high temperatures.
• After having disconnected your set, clean the case
with a soft cloth, or with a slightly damp leather
chamois. Never use strong solvents.
Protect your Components from
Overheating
• Do not block ventilation holes in any component.
Arrange the components so that air can circulate
freely.
• Do not stack components directly on top of each
other.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier near the top shelf of the stand
so heated air rising from it will not affect other com-
ponents. If you have a satellite receiver, you should
place it on the top shelf.
10 cm/4"
VOLUME
10 cm/
4"
SURR MODE
SETUP TEST TONE EQ DIGITAL INPUT BASS/TREBLE LEVEL
OK
DSP MODE
ST / MONO
V-AUX
VIDEO L - AUDIO - R
10 cm/4"
EN
3