Fine Setting Of The Speakers; Advanced Setting; Speaker Configurations - RCA RT2350 User Manual

Fine Setting of the Speakers

This receiver supports a wide range of speakers and
subwoofers. For optimal surround sound enjoyment,
you need to register the speaker selection settings of
your audio system. If you buy this receiver with
accompanied speaker package, then this step has
been done for you.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room,
you need to delay the signal from some of the speak-
ers. Such channel delay compensates for center or
surround speakers that are closer to listening position
than the front speakers. You can make use of the
SETUP button to adjust the speakers' relative loud-
ness.
The TEST TONE button
You can adjust the relative loudness of the individual
speakers by the TEST TONE button.
1. In Surround (Dolby Digital/Pro Logic/DTS) modes,
press TEST TONE briefly. A short noise will be heard
in the speakers one by one. The speaker having the
noise at that moment will be shown in the display.
SETUP TEST TONE
OK
2. To adjust the volume level of the test tone, turn
up/down the VOLUME knob or press VOL UP/DOWN
key on the remote control.
VOLUME
MODE
BASS/TREBLE LEVEL
MODE
3. To adjust individual speaker volume level, press the
LEVEL key on the main unit when the short noise is
played on the speaker you want to adjust then turn
the VOLUME knob to modify the output level.
BASS/TREBLE LEVEL
V-AUX
VIDEO L - AUDIO - R
S
EQ DIGITAL INPUT
ST / MONO
Advanced Sound Control
4. Press LEVEL again to save your setting.
5. Repeat step 3 to adjust other speaker volume lev-
els.
NOTE
To adjust the level of all speakers (center and
surround speakers), you must select Pro Logic
mode first by pressing the SURROUND key

Advanced Setting

Factory defaulted Advance setting indication
from VFD
The receiver has defaulted the following distances:
Front
Center
Left
Cch
Lch
L/S
Rear
Left

Speaker Configurations

You can also change the setup of the speakers by
pressing the SETUP button until the display shows
L/R SML or L/R LRG which enables you to set the size
of the front speaker.
Available Selections:
Front Speaker selection
Center Speaker selection
Surround Speaker selection
Subwoofer selection
Subwoofer Phase
Front Speaker distance
Centre Speaker distance
Rear Speaker distance
Pressing SETUP button once, while the display is still
showing L/R LRG, you may press the OK button to
toggle among: front, center, surround, subwoofer,
subwoofer phase and speakers' distance, sleep and
dimmer setup. Set the speaker size or speakers' dis-
tance by pressing UP/DOWN ARROW button.
Front
Right
Front speakers
(L/R) 15 ft
Rch
Center speaker
(Cch) 15 ft
R/S
Rear speaker
(SUR) 10 ft
Rear
Right
Large/ Small
Large/ Small/ None
Large/ Small/ None
Yes/ No
+ / -
3-40 ft
0-40 ft
0-40 ft
EN
21