Restarting The Mmi System (Reset); Speed Display On Driving School Vehicles; Other Settings - Audi MMI Navigation System plus Operating Manual

Restarting the MMI
system (Reset)
Fig. 22 Combination of buttons for restart
– Press and briefly hold the
the rotary pushbutton and the top right con-
trol button ð Fig. 22 simultaneously and
then release the buttons again.
Speed display on
driving school vehicles
Applies to vehicles: with equipment for driving schools
Select: MENU
►
ton Car systems* > Driver assist > Driving
school mode.
When this function is on, the speed of the ve-
hicle and the direction indicated by the turn
signals will appear on the MMI display.
When the mode is switched (e.g. to radio),
the vehicle speed and indicated direction will
appear again on the display after five seconds.
Note
– The additional speed display is only avail-
able for driving school vehicles.
– The value indicated in the speedometer
is the relevant speed.

Other settings

Select:
MENU
►
up MMI.
Language
oder Name, Abteilung, Datum
The language of texts shown on the MMI dis-
play and the driver information system as well
MENU button,
button > Car > control but-
button > control button Set-
as the language of the navigation cues* and
speech dialogue system* can be altered.
The number of languages available depends
on the market.
Measurement units
The following measurement units can be set
in the MMI display and the driver information
system:
– Speed (km/h or mph)
– Distance (km or miles)
– Temperature (°C or °F)
– Consumption (ltr/100 km, mpg (US), mpg
(UK) or km/ltr)
– Capacity (litres, gallons (UK) or gallons
(US))
Speech dialogue system*
Command display: The display of possible
commands during a speech dialogue can be
switched on/off.
Short dialogue: This option can be switched
on/off; when it is activated, the spoken cues
played by the system are abbreviated.
Volume settings: Turn the rotary pushbutton
to adjust the volume of the spoken cues.
Individual speech training (only possible
when the vehicle is stationary): You can use
the individual speech training to adapt the
speech dialogue system to your voice or pro-
nunciation so that the speech dialogue system
can then better recognise what you are saying.
The individual speech training prompts you to
repeat 20 spoken phrases that consist of cer-
tain commands and blocks of digits. If you
would like to delete the stored speech train-
ing setup, you can use the function Reset
speech training.
Display brightness
You can adjust the brightness of the MMI dis-
play by turning the rotary pushbutton.
Factory settings
You can reset the following functions to the
factory settings:
System settings

31