Error Codes And How To Handle Them; About Error Codes; Gt707 Series Error Codes - Panasonic AIG707WCL1G2 User Manual

4.2 Error Codes and How to Handle Them

4.2.1 About Error Codes

• When an error occurs in the GT series, an error code displays at the top right of the screen.
• There are two types of error codes, GT707 series error codes and PLC error codes.

4.2.2 GT707 Series Error Codes

 List of error codes
Code No. Content
**00FF Time up error
Keyboard screen data
**0100
parts digit error
**0101 Alarm history error
True Type font file
**0102
transfer error
**0500 Tool setting error
SD memory card not
**1000
inserted
SD memory card
**1001
writing error
SD memory card
**1002
memory full
SD memory card
**1003
reading error
SD memory card data
**1004
error
SD memory card
**1005
saved file name error
4.2 Error Codes and How to Handle Them
Cause and solution
The connection between the GT and PLC may not be correct. Check
the wiring of the connection cable and check for disconnection. Also,
there may be a temporary error due to noise, etc. Re-supply power to
the PLC and GT.
Check if the digit of the data parts on the keyboard screen has been set
correctly.
When updating the alarm history display is stopped, alarm history data
displayed on the GT's screen has been updated within the memory.
Once the stop of display update is cancelled, new data is displayed.
Screen data is not transferred correctly. Re-transfer data after deleting
all data.
The device that cannot be used is specified for the data. Check if the
used device is correct. (e.g. the word device is set in the bit area.)
An SD memory card is not inserted into the slot properly. Check the SD
memory card slot.
Data cannot be written into the SD memory card. Check whether the
SD memory card is not write-protected.
Data cannot be written as the memory of the SD memory card has
been exhausted. Delete some data in the SD memory card or prepare a
new SD memory card.
The data in the SD memory card cannot be read. Check whether the
saved data in the SD memory card is not damaged with a PC.
The data loaded from a SD memory card does not match the GT type.
Read the data in the SD memory card with GTWIN, and check whether
it is not damaged.
The file name to be saved to the SD memory card from the GT is not
specified properly. Specify the file name properly.
4-7